Honda CR-V: Brake System Indicator
The brake system indicator normally comes on when you turn the ignition switch to the ON (II) position, and as a reminder to check the parking brake. It will stay on if you do not fully release the parking brake.
If the brake system indicator comes on while driving, the brake fluid level is probably low. Press lightly on the brake pedal to see if it feels normal.
If it does, check the brake fluid level the next time you stop at a service station.
If the fluid level is low, take your vehicle to a dealer, and have the brake system inspected for leaks or worn brake pads.
However, if the brake pedal does not feel normal, you should take immediate action. A problem in one part of the system’s dual circuit design will still give you braking at two wheels. You will feel the brake pedal go down much farther before the vehicle begins to slow down, and you will have to press harder on the pedal.
Slow down by shifting to a lower gear, and pull to the side of the road when it is safe. Because of the long distance needed to stop, it is hazardous to drive the vehicle. You should have it towed and repaired as soon as possible (see Emergency Towing).
If you must drive the vehicle a short distance in this condition, drive slowly and carefully.
If the ABS indicator and the VSA system indicator come on with the brake system indicator, have your vehicle inspected by your dealer immediately.
READ NEXT:
Fuses
The vehicle’s fuses are contained in
three fuse boxes.
The interior fuse box is located
under the dashboard on the driver’s
side. The fuse label is attached
under the steering column.
Checking and Replacing Fuses
If something electrical in your
vehicle stops working, check for a
blown fuse first. Determine from the
chart on pages, or the
diagram on the fuse box lid, which
fuse or fuses control that d
Fuse Locations
INTERIOR FUSE BOX
UNDER-HOOD FUSE BOX
SEE MORE:
Knuckle/Hub Bearing Unit Replacement
Exploded View
Hub Bearing Unit Replacement
1. Raise the rear of the vehicle, and support it with safety stands in the
proper locations.
2. Remove the wheel nuts (A) and the rear wheel.
3. Remove the brake hose bracket mounting bolt (A)
from the knuckle.
4. Remove the brake caliper bracket mount
Installing a Child Seat with a Tether
A child seat with a tether can be
installed in any seating position in
the back seat.
Each rear outside seating position
has an anchorage point on the seatback,
and the center seating position
has an anchorage point in the ceiling
near the tailgate.
Since a tether can provide additiona
