Jeep Liberty: Reset
It may be necessary at some point in time to reactivate the Auto Up feature. To do so, perform the following procedure:
1. Pull the window switch up to close the window completely and continue to hold the switch up for an additional two seconds after the window is closed.
2. Push the window switch down firmly to the second detent to open the window completely and continue to hold the switch down for an additional two seconds after the window is fully open.
Auto Up Feature With Anti-Pinch Protection — If Equipped
On some models, the driver’s and front passenger’s (if equipped for passenger side) power window switches have an “Auto Up” feature. Pull the window switch fully upward to the second det ...Window Lockout Button
The window lockout button on the driver’s door trim panel allows you to disable the window control on the rear doors. To disable the window control on the other doors, press and release the wi ...See also:
Limitations of use
The DATABASE is restricted for use in the
specific system for which it was created.
Except to the extent explicitly permitted by
mandatory applicable laws, you may not
extract or re-utilise substa ...
Multi-function lever
Windshield wiper: Rotate the end
of the control away from you to
increase the speed of the wipers;
rotate towards you to decrease the
speed of the wipers.
Windshield washer: Press the end
of t ...
Brake fluid level
If you notice that the brake fluid level in the brake fluid reservoir has fallen
to the MIN mark or less, check the brake system immediately for leaks. Also check
the thickness of the brake lin ...