Range Rover Evoque: Before programming
When programming a device
that may
require you to press and re-press the
hand-held transmitter (cycle), unplug
the device during the cycling process to
prevent possible motor failure.
For best results, fit a new battery to the
hand-held transmitter of the garage door
opener (or other device) before programming.
If your garage door opener receiver (located in
the garage) is equipped with an antenna,
ensure that the antenna is hanging straight
down.
READ NEXT:
Programming
With the engine switched off;
1. Ensure that the ignition system is on.
2. Hold the signal emitting end of the original
garage door opener hand-held transmitter
50 to 150 mm (2 to 6
Note: The assistance of a second person, may
make the following steps quicker and easier.
Once the button has been pressed there are
only 30 seconds in which to complete Step 3.
1. At the garage d
To programme a device to a previously
programmed button:
1. Press and hold the desired
pre-programmed HomeLink button for at
least 20 seconds, but no longer than 30
seconds, until the indicator l
SEE MORE:
Battery Care
Requirements
1. INTRODUCTION
This document sets out the requirements for care and maintenance of batteries
and thereby the standard of battery care
at dealers and retailers for new vehicles
This applies to all types of 12 Volt Lead Acid Batteries used in Jaguar and Land
Rover vehicles
Front Door Latch
Removal
NOTES:
Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is
always correct.
Make sure the door window glass is in the fully closed position.
1. Refer to: Exterior Front Door Hand
© 2011-2024 Copyright www.rrevoque.org