GMC Terrain: Back–Up Lamp - Taillamps, Turn Signal, Sidemarker, Stoplamps, and Back-Up Lamps - Bulb Replacement - Vehicle Care - GMC Terrain Owner's ManualGMC Terrain: Back–Up Lamp

Removal of the lamp assembly is not required to replace the back-up lamp bulb.

To replace one of these lamps:

1. Open the liftgate. See Liftgate on page 2‑9.
2. Remove the interior trim access panel.

3. Turn the bulb socket counterclockwise and pull it out.

3. Turn the bulb socket counterclockwise and pull it out.
4. Pull the bulb straight out of the socket.
5. Install the new bulb.
6. Push the bulb socket in and turn it clockwise.
7. Reinstall the interior trim access panel.

    Auxiliary Taillamp
    To replace one of these lamps: 1. Open the liftgate. See Liftgate on page 2‑9. 2. Remove the interior trim access panel. A. Attachment Nuts B. Retaining Hook 3. Remove the five attachment ...

    License Plate Lamp
    To replace one of these bulbs: 1. Open the liftgate partway. See Liftgate on page 2‑9. Passenger Side Shown, Driver Side Similar 2. Push the left end of the lamp assembly toward the right. ...

    See also:

    Headlamp courtesy delay
    This feature operates whenever the lamps master switch is in the AUTO (5) position and the ignition is turned off. The headlamps will remain illuminated for up to 240 seconds. Note: The time delay ...

    Towing the Vehicle
    Notice: To avoid damage, the disabled vehicle should be towed with all four wheels off the ground. Care must be taken with vehicles that have low ground clearance and/or special equipment. Always ...

    Cup holder
    CAUTION: ● Do not drink beverages while driving. This is distracting and could cause an accident. For the driver’s seat There is a built-in cup holder in the instrument panel on the driv ...