Nissan Rogue: AWD warning light
The AWD warning light is located in the meter.
The AWD warning light illuminates when the ignition switch is turned to the ON position. It turns off soon after the engine is started.
If any malfunction occurs in the AWD system while the engine is running, the warning light will come on.
The warning light may blink rapidly (about twice per second) while trying to free a stuck vehicle due to high powertrain oil temperature. The driving mode may change to 2WD. AUTO mode may change to LOCK mode before the warning light blinks. If the warning light blinks rapidly during operation, stop the vehicle with the engine idling in a safe place immediately. Then if the light turns off after a while, you can continue driving.
A large difference between the diameters of front and rear wheels will make the warning light blink slowly (about once per two seconds). Pull off the road in a safe area, and idle the engine.
Check that all tire sizes are the same, tire pressure is correct and tires are not worn.
- If the warning light remains on after the above operation, have your vehicle checked by a NISSAN dealer as soon as possible.
- If the warning light comes on while driving there may be a malfunction in the AWD system. Reduce the vehicle speed and have your vehicle checked by a NISSAN dealer as soon as possible.
- The powertrain may be damaged if you continue driving with the warning light blinking rapidly.
- Never drive on dry hard surface roads in the LOCK mode, as this will overload the powertrain and may cause a serious malfunction.
All-Wheel Drive (AWD) lock switch operations
The AWD LOCK switch located on the lower
side of the instrument panel. This switch is used
to select the AUTO or LOCK mode depending
on the driving conditions.
Each time you push the lower pa ...
Parking/parking on hills
- Do not stop or park the vehicle over
flammable materials such as dry
grass, waste paper or rags. They
may ignite and cause a fire.
- Safe parking procedures require
that both the park ...
See also:
Sport mode
The stability system is always activated and
cannot be switched off.
However, the driver can select Sport mode,
which offers more active driving characteristics.
In this mode, the engine managem ...
Cellular and GPS Antennas
Avoid placing items over or near the antenna to prevent blocking cellular and
GPS signal reception. Cellular reception is required for OnStar to send remote signals
to the vehicle. ...
Three-Way Calling
Three-way calling must be supported on the cell phone and enabled by the wireless
service carrier.
1. While on a call, press .
2. Say “Three&-way call.”
3. Use the dial or call command to ...
