Range Rover Evoque: Automatic switch off
Cruise control will switch off but the set speed
will remain in the memory when:
- The CAN button (3) is pressed.
- The brake pedal is pressed.
- Speed falls below 30km/h (18mph).
- Neutral, Park or Reverse gear is selected
on vehicles with automatic transmission.
- Dynamic Stability Control is operating.
- The difference between the actual and set
speed is too great.
- The vehicle reaches a speed of 170km/h
(105.6mph).
- The accelerator pedal is used to accelerate
beyond the set speed for too long a period.
Cruise control will switch off and clear the
memory when:
- The ignition system is switched off.
- A fault occurs. The cruise control system
will switch off and cannot be used until the
fault is cleared.
READ NEXT:
Diesel only
When enabled, a CO2 emission indicator is
displayed in the message centre. The higher
the numeric reading, the more CO2 is being
emitted and the more fuel is being used. See
56, VEH
DSC is automatically enabled each time the
engine is started, and is automatically enabled
by some of the Terrain response special
programs.
The vehicle is not designed
for
cornering at the sa
SEE MORE:
Special Tool(s)
205-857
Remover, Halfshaft
303-021
Engine support bracket
303-662
Support Beam Arm and Hook Assembly, Engine
JLR-303-1591
Lifting Bracket, Engine - Rear
General Equipment
Transmission jack
NOTE: Some variation in the illustrations may occur, but the essential
information is alway
Check the tyre sidewall prior
to
inflation. If there are any cracks,
bumps or similar damage, do not
attempt to inflate the tyre. Do not
stand directly beside the tyre while
the compressor is pumping. Watch the
tyre sidewall: If any cracks, bumps or
similar damage appear, turn off the
com
© 2011-2024 Copyright www.rrevoque.org