Volvo XC60: Automatic standby mode
Adaptive cruise control is linked to other systems such as the stability and traction control system (DSTC). If this system is not functioning properly, adaptive cruise control is automatically deactivated and will go into standby mode.
In the event of automatic deactivation, an audible signal will sound and the message Cruise control Cancelled is shown in the display.
The driver must then intervene and adapt the vehicle's speed to the surrounding traffic and regulate the distance to the vehicle ahead.
An automatic switch to standby mode may be
caused if:
• the wheels lose traction
• brake temperature is high
• the radar sensor is obstructed by, for
example, wet snow or rain.
Standby mode due to action by the driver
ACC is temporarily deactivated and put in standby mode: • when the brakes are applied • if the driver's seat belt is taken off • If the driver's door is opened • if the gear selector is ...Queue Assist
The following functions are linked to your vehicle's automatic transmission and comprise the Queue Assist feature. Please note that the lowest speed that can be set is 18 mph (30 km/h), althoug ...See also:
Recreational towing (behind motorhome, etc.)
Two-Wheel Drive Models
All Four Wheels On The Ground
Recreational towing is allowed ONLY if the driveshaft is
removed. Towing with the rear wheels on the ground
while the driveshaft is connected ...
Glove box
1 Unlock with the master key
(vehicles without smart key
system) or mechanical key
(vehicles with smart key system)
2 Lock with the master key
(vehicles without smart key
system) or mechanical ...
To disable TRAC and/or VSC (4WD models)
If the vehicle gets stuck in fresh snow or mud, TRAC and VSC may
reduce power from the engine to the wheels. You may need to turn
the system off to enable you to rock the vehicle in order to free it ...