Jeep Liberty: Auto Up Feature With Anti-Pinch Protection — If Equipped
On some models, the driver’s and front passenger’s (if equipped for passenger side) power window switches have an “Auto Up” feature. Pull the window switch fully upward to the second detent, release, and the window will go up automatically.
To stop the window from going all the way up during the Auto Up operation, push down on the switch briefly.
To close the window part way, pull the window switch up to the first detent and release when you want the window to stop.
For vehicles not equipped with the Electronic Vehicle Information Center (EVIC), the power window switches will remain active for 45 seconds after the ignition switch is turned to the LOCK position. Opening either front door will cancel this feature.
For vehicles equipped with the EVIC, the power window switches will remain active for up to 10 minutes after the ignition switch is turned to the LOCK position. Opening either front door will cancel this feature. The time is programmable. Refer to “Electronic Vehicle Information Center (EVIC)/Personal Settings (Customer-Programmable Features)” in “Understanding Your Instrument Panel” for further information.
NOTE:
• If the window runs into any obstacle during autoclosure,
it will reverse direction and then go back
down. Remove the obstacle and use the window
switch again to close the window.
• Any impact due to rough road conditions may trigger the auto reverse function unexpectedly during autoclosure.
If this happens, pull the switch lightly to the first detent and hold to close window manually.
WARNING!
There is no anti-pinch protection when the window
is almost closed. Be sure to clear all objects from the
window before closing.
Auto-Down Feature
The driver’s and front passenger’s (if equipped for passenger side) power window switches have an “Auto- Down” feature. Press the window switch past the first detent, release, and the wi ...Reset
It may be necessary at some point in time to reactivate the Auto Up feature. To do so, perform the following procedure: 1. Pull the window switch up to close the window completely and continue to ...See also:
Tilt operation
Tilt operation
Pull the lock lever down 1 and adjust the
steering wheel up or down 2 to the desired
position.
Push the lock lever up 3 securely to lock the
steering wheel in place. A clickin ...
Using panic alarm
If you are near your vehicle and feel threatened,
you may activate the alarm to call attention as
follows:
1. Push the PANIC button 3 on the
Intelligent Key for more than 1 second.
2. The th ...
General warning/information message (amber)
General warning/information message (amber)
Illuminates when a non-critical
warning message or an
information message is available in
the message centre. ...