Nissan Rogue: Auto-reverse function (if so equipped)
There are some small distances immediately before the closed position which cannot be detected. Make sure that all passengers have their hands, etc., inside the vehicle before closing the window.
If the control unit detects something caught in the window as it is closing, the window will be immediately lowered.
The auto reverse function can be activated when the window is closed by automatic operation when the ignition switch is in the ON position or for 45 seconds after the ignition switch is turned to the OFF position.
Depending on the environment or driving conditions, the auto reverse function may be activated if an impact or load similar to something being caught in the window occurs.
Automatic operation (if so equipped)
Automatic operation (if so equipped) The automatic operation is available for the switch that has an mark on its surface. Type A: To fully open or close the window, push down or pull up the s ...If the windows do not close automatically
If the power window automatic function (closing only) does not operate properly, perform the following procedure to initialize the power window system. 1. Turn the ignition switch to the ON pos ...See also:
Vehicle load limit
Tire and loading information label The tire label located on the driver's door
sill gives the original tire size, cold tire pressures recommended for your vehicle,
the number of people that ...
Engine Block Heater — If Equipped
The engine block heater warms the engine, and permits
quicker starts in cold weather. Connect the cord to a
standard 110-115 Volt AC electrical outlet with a
grounded three-wire extension cord.
...
Installing a Child Seat with a Lap/Shoulder Belt
When not using the LATCH system,
all child seats must be secured to the
vehicle with the lap part of a lap/
shoulder belt.
In addition, the lap/shoulder belts in
all seating positions except ...