Range Rover Evoque: Attaching tether straps

1. Install the child restraint securely in one of the rear seating positions.

2. Pass the tether strap over the seat back and beneath the head restraint.

3. Attach the tether strap hook to the tether anchor point on the back of the seat.

Ensure that the tether strap hook is facing the correct way.

4. Tighten the tether strap according to the manufacturer's instructions.

READ NEXT:

 Airbag supplementary restraint system (SRS)

Airbag supplementary restraint system (SRS) 1. Front passenger’s airbag 2. Curtain airbags 3. Side airbags 4. Knee-bolster airbag 5. Driver’s airbag Note: The general location of airbags f

 Airbag operation

For the airbags to operate correctly the roof lining and door post trims must be in good condition, correctly fitted, and free from obstruction. Any damage, wear, or incorrect fitment should b

 Disabling the passenger airbag (not Australia)

Crash test data and statistics show that the safest place for a child to be restrained is in a child seat correctly fitted to the vehicle's rear seat. Do not use a child restraint on a seat pr

SEE MORE:

 Headlamps

Moving the nearside headlamp unit to access bulbs; 1. Remove the two plastic fixings. 2. Pull the tube up to release from the air box. This will allow more room for manoeuvrability. 3. Remove the four grille fixings. 4. Remove the two retaining bolts. 5. At the rear of the headlamp unit, p

 Block Heater

Removal 1. Refer to: Cooling System Partial Draining, Filling and Bleeding (303-03B Engine Cooling - GTDi 2.0L Petrol, General Procedures). 2. Refer to: Engine Undershield (501-02 Front End Body Panels, Removal and Installation). 3. Refer to: Front Bumper Cover (501-19 Bumpers, Removal and Installat

© 2011-2024 Copyright www.rrevoque.org