Subaru Forester: Adjusting the front seat shoulder belt anchor height
Adjusting the front seat shoulder belt anchor height
The shoulder belt anchor height should be adjusted to the position best suited for the driver/front passenger. Always adjust the anchor height so that the shoulder belt passes over the middle of the shoulder without touching the neck.
To raise:
Slide the anchor up.
To lower:
Pull the release knob and slide the anchor
down.
Pull down on the anchor to make sure that it is locked in place.
When wearing the seatbelts, make sure the shoulder portion of the webbing does not pass over your neck. If it does, adjust the seatbelt anchor to a lower position. Placing the shoulder belt over the neck may result in neck injury during sudden braking or in a collision.
Front seatbelts
1. Adjust the seat position according to the following procedure. Driver’s seat: Adjust the seatback to the upright position. Move the seat as far from the steering wheel as practical while s ...Unfastening the seatbelt
Unfastening the seatbelt Push the button on the buckle. Before closing the door, make sure that the belts are retracted properly to avoid catching the belt webbing in the door. ...See also:
Operation
Controls and display
1 Resume previous settings, increase speed (each additional press increases
speed by 1 mph (approximately 2 km/h).
2 Standby mode on/off
3 Set time interval
4 Put in activ ...
Seat belts
Do not allow any water,
cleaning
products, or fabric from cloths to enter
the seat belt mechanism. Any
substance which enters the
mechanism may affect the
performance of the seat belt in an
i ...
Easy route
In Route options, Easy route can be turned On
or Off.
When On is selected, Easy route changes the
calculation parameters of Route 3 in order to
reduce:
- Junctions.
- Turns.
- Turns that cross ...