Nissan Rogue: Wheels - Cleaning exterior - Appearance and care - Nissan Rogue Owner's ManualNissan Rogue: Wheels

Wash the wheels when washing the vehicle to maintain their appearance.

- Clean the inner side of the wheels when the wheel is changed or the underside of the vehicle is washed.

- Inspect wheel rims regularly for dents or corrosion. Such damage may cause loss of pressure or poor seal at the tire bead.

- NISSAN recommends that the road wheels be waxed to protect against road salt in areas where it is used during winter.

Do not use abrasive cleaners when

Do not use abrasive cleaners when washing the wheels.

Aluminum alloy wheels

Wash regularly with a sponge dampened in a mild soap solution, especially during winter months in areas where road salt is used. Salt could discolor the wheels if not removed.

Follow the directions below to avoid

Follow the directions below to avoid staining or discoloring the wheels:
- Do not use a cleaner that uses strong acid or alkali contents to clean the wheels.

- Do not apply wheel cleaners to the wheels when they are hot. The wheel temperature should be the same as ambient temperature.

- Rinse the wheel to completely remove the cleaner within 15 minutes after the cleaner is applied.

    Glass
    Use glass cleaner to remove smoke and dust film from the glass surfaces. It is normal for glass to become coated with a film after the vehicle is parked in the hot sun. Glass cleaner and a soft ...

    Chrome parts
    Clean chrome parts regularly with a nonabrasive chrome polish to maintain the finish. ...

    See also:

    Cleaning The Parksense System
    Clean the ParkSense sensors with water, car wash soap and a soft cloth. Do not use rough or hard cloths. Do not scratch or poke the sensors. Otherwise, you could damage the sensors. ...

    Land rover tyre repair kit
    Land rover tyre repair kit 1. Maximum speed label. 80 km/h (50 mph). 2. Tyre inflation hose. 3. Inflation hose protective cap. 4. Inflation hose connector. 5. Compressor power cable. 6. Power ...

    Reset
    It may be necessary at some point in time to reactivate the Auto Up feature. To do so, perform the following procedure: 1. Pull the window switch up to close the window completely and continue to ...