Range Rover Evoque: Wheel changing

SHOULD PLACE ANY PORTION OF WARNING - THAT NO PERSON SHOULD PLACE ANY PORTION OF THEIR BODY UNDER A VEHICLE THAT IS SUPPORTED BY A JACK.
Position the jack from the side of the vehicle, in line with the appropriate jacking point.

only the Jack up the vehicle using only the jacking points described, or damage to the vehicle could occur.

Note: Your vehicle may be fitted with a tilt sensor which activates the alarm if the vehicle is tilted in any direction after it has been locked.
To lock the doors while changing the wheel, and avoid the alarm activating, tilt sensor can be temporarily disabled. See 56, VEHICLE INFORMATION AND SETTINGS MENU.

Before rasing the vehicle, use the wheel nut brace to slacken the wheel nuts half a turn counter clockwise.

1. Locate the jack under the relevant jacking

1. Locate the jack under the relevant jacking point.

Note: Do not allow the jack to contact the sill at any other point as damage may result.

Note: The Sports pack sills include arrows to identify jacking points.

2. Attach the cranking lever to the jack using the adaptor. Fit the wheel nut brace to the end of the cranking lever.

3. Rotate clockwise to raise until the jack pin locates into the jacking point.

4. Continue raising the vehicle until the wheel is clear of the ground.

5. Remove the wheel nuts and place them together where they cannot roll away.

6. Remove the wheel and place to one side.

Do not lay the wheel on its face, as this may damage the finish.

7. Fit the temporary spare wheel to the hub.

8. Re-fit the wheel nuts and lightly tighten them. Ensure that the wheel is making contact with the hub evenly.

9. Ensure that the space under the vehicle is clear of obstructions and lower the vehicle slowly and smoothly.

10. With all wheels on the ground and the jack removed, fully tighten the wheel nuts. The wheel nuts must be tightened in sequence (see illustration) to the correct torque of 133 Nm (98 lb.ft).

Note: If it is not possible to torque the wheel

Note: If it is not possible to torque the wheel nuts when a wheel is replaced, they should be set to the correct torque as soon as possible.

Check and adjust the tyre pressure as soon as possible.

READ NEXT:

 Tyres

 Tyre care

Do not drive the vehicle if a tyre is damaged, excessively worn, or incorrectly inflated. Avoid contaminating the tyres with vehicle fluids as they may cause damage to the tyre. Avoid spinnin

 Tyre pressures

Never drive your vehicle if the tyre pressures are incorrect. Pressure checks should only be carried out when the tyres are cold, and the vehicle has been stationary for more than three hours.

SEE MORE:

 Timed climate remote control

The dedicated remote control has a range of approximately 100m (328ft). Press and hold the ON button for two seconds. Note: Avoid touching the antenna when operating the ON or OFF button. Timed climate remote control 1. On button. 2. Off button. 3. LED (operation indicator). 4. Antenna.

 Front Seat Backrest Cover

Removal WARNINGS: To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before repairing or replacing any air bag supplemental restraint system (SRS) components. To deplete the backup power supply energy, disconnect the battery ground cable and wait

© 2011-2024 Copyright www.rrevoque.org