Ford Escape: Compass zone adjustment
1. Determine which magnetic zone
you are in for your geographic
location by referring to the zone
map.
2. Turn ignition to the on position.
3. Start the engine.
4. Press the SETUP control to select the Update Zone function and display the current ZONE XX in the center stack display.
5. Continue to press the RESET control until the correct zone appears in the center stack display.
6. The direction will display after the RESET control is released. The zone is now updated.
Electronic compass (if equipped)
The compass heading is displayed in the center stack display. The compass reading may be affected when you drive near large buildings, bridges, power lines and powerful broadcast antenna. Magnetic ...Compass calibration adjustment
Perform compass calibration in an open area free from steel structures and high voltage lines. For optimum calibration, turn off all electrical accessories (heater/air conditioning, wipers, etc.) an ...See also:
Memory status
In phone mode, the memory status of the infotainment
system's phone book and the connected
cell phone's phone book can be seen
in Phone menu
Phone book
Memory
status. ...
Scanning radio stations
■ Scanning the preset radio stations
1 Press and holduntil you hear a
beep.
Preset stations will be played for 5 seconds each.
2 When the desired station is reached, press
once
again.
& ...
To remove the second row cushion
1. Lift the yellow tab to release the
hinges.
2. Pull the cushion to the outboard
side of the vehicle.
...