Ford Escape: Replacing high-mount brake lamp bulbs
1. Remove the two screws and move the lamp assembly away from the liftgate.
2. Remove the bulb holder from the lamp assembly by pressing the snaps.
3. Pull the bulb straight out of the socket and push in the new bulb.
Install the new bulbs in reverse order.
Replacing tail/stop/turn/backup lamp bulbs
The tail/stop/turn/sidemarker/backup lamp bulbs are located in the same portion of the tail lamp assembly, one just below the other. Follow the same steps to replace either bulb: 1. Make sure the ...Replacing license plate lamp bulbs
1. Make sure the headlamp switch is in the off position. 2. Press the lever and carefully pry the license plate lamp assembly (located above the license plate) from the liftgate. 3. Rotate the b ...See also:
How To Use Remote Start
All of the following conditions must be met before the
engine will remote start:
• Shift lever in PARK.
• Doors closed.
• Hood closed.
• Liftgate closed.
• Hazard switch off.
â ...
Emission Compliance Label (for U.S.A.)
Emission Compliance
Label (for U.S.A.)
The EPA emission compliance label is located under the hood. ...
Seat belt extenders
If, because of body size or driving position, it is
not possible to properly fit the lap-shoulder belt
and fasten it, an extender that is compatible with
the installed seat belts is available th ...