Range Rover Evoque: Trailer electrical connection
Land Rover Range Rover Evoque L538 (2011–2018) Owner's Manual / Towing / Trailer electrical connection
Connect only approved
electrical
circuits, which are in good condition, to
the trailer socket.
The vehicle connector provides a 5 amp output which must not be exceeded. An accessory harness kit increasing output to 15 amp is available from your Land Rover Dealer.
When a trailer electrical connection is made and the vehicle’s direction indicators are used, the trailer warning indicator will flash in time with the direction indicators.
READ NEXT:
Powered tailgate
When towing, ensure there is
sufficient
clearance before opening or closing the
tailgate.
Parking aids
The rear parking aids sensors are automatically
disabled when a trailer with an approved
electrical connector is connected.
Note: Trailers fitted with LED lights will not
disable the rear parking
Trailer stability assist (TSA)
When a trailer is attached, TSA will
automatically detect when a trailer sway is
developing. It will then gradually reduce vehicle
speed by cutting engine power and applying
the brakes to help reg
SEE MORE:
Active
On-demand Coupling Control Module
Rear Differential Control Module (RDCM)
CAUTION:
Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution
of control modules does
not guarantee confirmation of a fault, and may also cause additional faults in
the vehicle being tested and/or the donor
vehicle.
NOT
Active On-Demand Coupling Vehicles With:
AWF21 6-Speed Automatic Transmission
Removal
1. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
2. Refer to: Exhaust System (309-00B Exhaust System - TD4 2.2L
Diesel, Removal and Installation).
3. CAUTION: Make sure that the driveshaft is
supported with suitable retaining straps.
4. CAUTIONS:
© 2011-2024 Copyright www.rrevoque.org
