Honda CR-V: To Change or Select Files

Use the SKIP button while a USB flash memory device is playing to change files.

SKIP - Each time you press and release skips forward to the beginning of the (preset 6), the player skips forward to the beginning of the next file. Press and release to  (preset 5), to skip backward to the beginning of the current file.

Press it again to skip to the beginning of the previous file.

FF/REW - To move rapidly within a file, press and hold or  (preset 3). (preset 4) or FOLDER SELECTION - To (preset 3).

FOLDER SELECTION - To select a different folder, press either side of the TUNE bar. Press the and press the  side to skip to the side to skip to the next folder, and press the beginning of the previous folder. side to skip to the beginning of the previous folder.

READ NEXT:

 Using a Track List

You can also select a file directly from a track list on the audio display. Press the AUDIO button to show the audio display, then touch the Track List icon. The track list menu appears on

 To Stop Playing a USB Flash Memory Device

To play the radio, press the AM/FM button or touch the FM1, FM2, AM, XM1, or XM2 icon. Touch the CD icon to switch to the disc mode (if a disc is loaded). Each time you press the CD/XM butto

 Disconnecting a USB Flash Memory Device

You can disconnect the USB flash memory device at any time even if the USB mode is selected on the audio system. Always follow the USB flash memory device’s instructions when you remove it

SEE MORE:

 Potential Vehicle Hazards

Carbon Monoxide poison from engine exhaust. Be sure there is adequate ventilation whenever you operate the engine. Burns from hot parts. Let the engine and exhaust system cool down before touching any parts. Injury from moving parts. Do not run the engine unless instructed to do so.

 Boot Band Installation

Special Tools Required Boot band tool, KD-3191 or equivalent, commercially available Boot band pliers, Kent-Moore J-35910 or equivalent, commercially available Double Loop Type 1. Fit the boot ends onto the driveshaft and the inboard joint, then install the new double loop band (A) onto the boot. N

© 2016-2024 Copyright www.hcrv.net