Toyota RAV4: Taking out the spare tire (vehicles without the spare tire cover)
Using the wheel nut wrench, loosen the hold-down nuts by turning them counterclockwise until they can be loosened by hand. Follow the order shown in the illustration.
2 Remove all the wheel nuts and the spare tire. When placing the spare tire on the ground, make sure the wheel design side faces up to avoid scratching the wheel surface.
Taking out the spare tire (vehicles with the spare tire cover)
Open the back door. Unlock the latch handle which is on the bottom of the spare tire cover. 2 Close the back door. Remove the spare tire cover by holding the bottom and lifting it up and awa ...Replacing a flat tire
Chock the tires. 2 Remove the wheel ornament using the wheel nut wrench as shown below. 16-inch wheel To protect the wheel ornament, place a rag between the wrench and the wheel ornament, ...See also:
Switching off the rear screens
Both of rear screens can be switched off from
the front center control panel. This function can
be activated under RSE settings
Display
off as explained in points 2-4 in the section
" ...
Fasten and Position the Seat Belts
Insert the latch plate into the buckle,
then tug on the belt to make sure the
belt is securely latched. Check that
the belt is not twisted, because a
twisted belt can cause serious
injuries ...
After the operation
1. Lower the vehicle carefully to the ground.
2. Dispose of waste oil and filter properly.
- Prolonged and repeated contact
with used engine oil may cause skin
cancer.
- Try to avoid direct ...