Nissan Rogue: ON position
When the switch is in the ON position 1 , the map lights will illuminate.
Map lights
Map lights Push the light lens to turn the map light on or off. The map light control switch has three positions: ON 1 , DOOR 2 and OFF 3 . The light 4 (if so equipped) will illuminate when t ...DOOR position
When the switch is in the DOOR position 2 the map lights will illuminate under the following conditions: - ignition switch is turned to the LOCK position — remain on for about 15 seconds. ...See also:
Leaving After Parking on a Hill
1. Apply and hold the brake pedal.
2. Start the engine.
3. Shift into a gear.
4. Release the parking brake.
5. Let up on the brake pedal.
6. Drive slowly until the trailer is clear of the chocks. ...
Erasing the Car2U Home Automation System buttons
Note: The system allows for three devices to be programmed. If you
need to change or replace any of the three devices after it has been
initially programmed, it will be necessary to erase the curren ...
Using the SmartKey
The SmartKey must be close to the driver's door handle.
Point the tip of the SmartKey at the driver's door handle.
Press and hold the button
until the side windows and the panoram ...