Hyundai Tucson: Higher speed motoring
Pre-Trip Inspections
1. Tires: Adjust the tire inflation pressures to specification. Low tire inflation pressures will result in overheating and possible failure of the tires. Avoid using worn or damaged tires which may result in reduced traction or tire failure.
NOTE: Never exceed the maximum tire inflation pressure shown on the tires.
WARNING: o Underinflated or overinflated tires can cause poor handling, loss of vehicle control, and sudden tire failure leading to accidents, injuries, and even death. Always check tires are properly inflated before driving. Refer to pages 2-28 and 8-3 for proper tire pressures and further information. o Driving on tires with no or insufficient tread is dangerous. Worn-out tires can result in loss of vehicle control, collisions, injury, and even death. Worn-out tires should be replaced as soon as possible and should never be used for driving. Always check tire tread before driving your car. Refer to 8-11 for further information and tread limits.
2. Fuel, engine coolant and engine oil: High speed travel consumes more fuel than urban motoring. Do not forget to check both engine coolant and engine oil. 3. Drive belt: A loose or damaged drive belt may result in overheating of the engine.
Winter driving
The more severe weather conditions of winter result in greater wear and other problems. To minimize the problems of winter driving, you should follow these suggestions: Snowy or Icy Conditions ...Use of lights
Check your lights regularly for correct operation and always keep them clean. When driving during the day in conditions of poor visibility, it is helpful to drive with headlights on low beam. ...See also:
Windshield and Wiper Blades
Clean the outside of the windshield with glass cleaner.
Clean rubber blades using a lint-free cloth or paper towel soaked with windshield
washer fluid or a mild detergent. Wash the windshield thoro ...
Collision Alert
When your vehicle approaches another vehicle too rapidly, the red FCA display
will flash and sound several beeps. When this occurs, the brake system prepares
for driver braking to occur more rap ...
Checking and replacing fuses
Replacing a Fusible Link
A fusible link will melt if the electrical circuits from
the battery are ever overloaded, thus preventing
damage to the entire wiring harness. (This
could be caused ...