Jeep Liberty: Turn Signals
Move the multifunction lever up or down and the arrows on each side of the instrument cluster flash to show proper operation of the front and rear turn signal lights.
Turn Signal Control
NOTE: If either light remains on and does not flash, or there is a very fast flash rate, check for a defective outside light bulb. If an indicator fails to light when the lever is moved, it would suggest that the indicator bulb is defective.
Lane Change Assist
Tap the lever up or down once, without moving beyond the detent, and the turn signal (right or left) will flash three times then automatically turn off.
Fog Lights — If Equipped
To activate the front fog lights, turn on the parking lights or the low beam headlights and pull out on the end of the multifunction lever. Front Fog Light Control NOTE: The front fog lights ...High/Low Beam Switch
Push the multifunction lever away from you to switch the headlights to high beam. Pull the multifunction lever toward you, to switch the headlights back to low beam. ...See also:
Important safety notes
WARNING
The PARKTRONIC is a supplemental system. It is not intended to, nor does it replace,
the need for extreme care. The responsibility during parking and other critical
maneuvers always ...
Low beam, Halogen
1. Remove the headlight housing from the
vehicle (see page 322).
2. Remove the cover over the bulbs (see
page 323).
3. Unplug the connector from the bulb.
4. Remove the bulb by pressing the h ...
Replacement Keys
NOTE: Only keys that are programmed to the vehicle
electronics can be used to start and operate the vehicle.
Once a Sentry Key is programmed to a vehicle, it cannot
be programmed to any other veh ...