Jeep Liberty: Adjustable Upper Shoulder Belt Anchorage - Lap/Shoulder Belts - Occupant Restraints - Things To Know Before Starting Your Vehicle - Jeep Liberty Owner's ManualJeep Liberty: Adjustable Upper Shoulder Belt Anchorage

In the front seating positions, the shoulder belt can be adjusted upward or downward to position the belt away from your neck. Press the release button to release the anchorage, and then move it up or down to the position that fits you best.

NOTE: The adjustable upper shoulder belt anchorage is equipped with an Easy Up feature. This feature allows the shoulder belt anchorage to be adjusted in the upward position without pressing the release button. To verify the shoulder belt anchorage is latched, pull downward on the shoulder belt anchorage until it is locked into position.

Adjusting Upper Shoulder Belt
Adjusting Upper Shoulder Belt

As a guide, if you are shorter than average, you will prefer a lower position, and if you are taller than average, you will prefer a higher position.

    Lap/Shoulder Belt Operating Instructions
    1. Enter the vehicle and close the door. Sit back and adjust the seat. 2. The seat belt latch plate is located on the B-Pillar along the outboard side and rear of the seat cushion. The rear sea ...

    Lap/Shoulder Belt Untwisting Procedure
    Use the following procedure to untwist a twisted lap/ shoulder belt. 1. Position the latch plate as close as possible to the anchor point. 2. At about 6 to 12 in (15 to 30 cm) above the latch pl ...

    See also:

    Type D audio set (if equipped)
    Type D audio set (if equipped) The audio set will operate only when the ignition switch is in the “Acc” or “ON” position. - Power and audio controls: refer to page - Radio operation: ...

    Electronic Serial Number/Sirius Identification Number (ESN/SID)
    Please have the following information available when calling: 1. The Electronic Serial Number/Sirius Identification Number (ESN/SID). 2. Your Vehicle Identification Number. To access the ESN/SI ...

    Erasing HomeLink Buttons
    To erase programming from the three Home- Link buttons (individual buttons cannot be erased but can be “reprogrammed” as outlined below), follow the step noted: 1. Press and hold the two ou ...