Jeep Liberty: Service The Parksense Rear Park Assist System
When the ParkSense Rear Park Assist System is malfunctioning, the instrument cluster will actuate a single chime, once per ignition cycle, and it will display the “SERVICE PARK ASSIST SYSTEM” message. Refer to “Electronic Vehicle Information Center (EVIC)” in “Understanding Your Instrument Panel” for further information.
When the shift lever is moved to REVERSE and the system has detected a faulted condition, the EVIC will display the “SERVICE PARK ASSIST SYSTEM” message for as long as the vehicle is in REVERSE. Under this condition, ParkSense will not operate.
If “SERVICE PARK ASSIST SYSTEM” appears in the EVIC make sure the rear fascia/bumper is clean and clear of snow, ice, mud, dirt or other obstruction and then cycle the ignition. If the message appears again, see an authorized dealer.
Enabling And Disabling Parksense
ParkSense can be enabled and disabled with a switch located in the switch bank of the instrument panel or through the Customer-Programmable Features section of the EVIC. The available choices ar ...Cleaning The Parksense System
Clean the ParkSense sensors with water, car wash soap and a soft cloth. Do not use rough or hard cloths. Do not scratch or poke the sensors. Otherwise, you could damage the sensors. ...See also:
Parking Brake
To set the parking brake, hold the regular brake pedal down, then push the parking
brake pedal down.
If the ignition is on, the brake system warning light will come on. See Brake
System Warning ...
Tyre change
Valve stem seal, washer, nut,
valve core
and cap should be replaced at every tyre
change. Valve stem seal, washer and
nut must be replaced if valve retention
nut is loosened. Sensor units and n ...
Tire Changing Tool
Tire Changing
Tool
The jack, wheel brace and jack handle are stowed in the rear left corner of the
luggage compartment. Remove the cover to access the tools. To remove the jack, turn
its shaft ...