Jeep Liberty: Reset
• press the button.
• After the “Ready” prompt, and the following beep, say “Setup”, then “Reset”.
This will delete all phone pairing, phone book entries, and other settings in all language modes. The System will prompt you before resetting to factory settings.
Voice Training
For users experiencing difficulty with the system recognizing their voice commands or numbers, the Uconnect™ Phone Voice Training feature may be used. To enter this training mode, follow one o ...Voice Command
• For best performance, adjust the rearview mirror to provide at least 1⁄2 in (1 cm) gap between the overhead console (if equipped) and the mirror. • Always wait for the beep before spe ...See also:
Rear seats
■ Second seats
Vehicles with third seat
1 Seat position adjustment
levers
2 Seatback angle adjustment
levers
When a person sits in the rear
center position, adjust both
seat cushions t ...
Windshield Wiper/Washer
The windshield wiper/washer lever is located on the right side of the steering
column. With the ignition in ACC/ACCESSORY or ON/RUN/ START, move the windshield
wiper lever to select the wiper sp ...
Fuel consumption
The fuel consumption figures shown below have been calculated using a
standard testing
procedure (the new EC test procedure from Directive 99/100/EC), and produced in
accordance with
The Passeng ...