Jeep Liberty: Voice Command System Operation
This Voice Command system allows you to control your AM, FM radio, satellite radio, disc player, and a memo recorder.
NOTE: Take care to speak into the Voice Interface System as calmly and normally as possible. The ability of the Voice Interface System to recognize user voice commands may be negatively affected by rapid speaking or a raised voice level.
WARNING!
Any voice commanded system should be used only
in safe driving conditions following local laws. All
attention should be kept on the roadway ahead.
Failure to do so may result in a collision causing serious injury or death.
When you press the Voice Command button, you will hear a beep. The beep is your signal to give a command.
NOTE: If you do not say a command within a few seconds, the system will present you with a list of options.
If you ever wish to interrupt the system while it lists options, press the Voice Command button, listen for the beep, and say your command.
Pressing the Voice Command button while the system is speaking is known as “barging in.” The system will be interrupted, and after the beep, you can add or change commands. This will become helpful once you start to learn the options.
NOTE: At any time, you can say the words “Cancel”, “Help” or “Main Menu”.
These commands are universal and can be used from any menu. All other commands can be used depending upon the active application.
When using this system, you should speak clearly and at a normal speaking volume.
The system will best recognize your speech if the windows are closed, and the heater/air conditioning fan is set to low.
At any point, if the system does not recognize one of your commands, you will be prompted to repeat it.
To hear the first available Menu, press the Voice Command button and say “Help” or “Main Menu”.
Commands
The Voice Command system understands two types of commands. Universal commands are available at all times. Local commands are available if the supported radio mode is active. ...See also:
If your vehicle goes off the edge of the pavement
• If your vehicle goes off the edge of the pavement, slow down, but
avoid severe brake application, ease the vehicle back onto the
pavement only after reducing your speed. Do not turn the steering ...
How to change a tyre
Before changing a tyre, first stop your vehicle in a safe, flat location. 1.
Park the vehicle on level and stable ground, free of loose pebbles, etc.. 2. Set
the parking brake firmly. 3. Turn the ...
Ignition Switch Light
The ignition switch light comes on
when you open the driver’s door. It
fades out in about 30 seconds after
the door is closed. ...