Jeep Liberty: Security
It is advised to erase all channels before you sell or turn in your vehicle.
To do this, press and hold the two outside buttons for 20 seconds until the red indicator flashes. Note that all channels will be erased. Individual channels cannot be erased.
The HomeLink Universal Transceiver is disabled when the Vehicle Security Alarm is active.
Using HomeLink
To operate, press and release the programmed HomeLink button. Activation will now occur for the programmed device (i.e., garage door opener, gate operator, security system, entry door lock, home ...Troubleshooting Tips
If you are having trouble programming HomeLink , here are some of the most common solutions: • Replace the battery in the original hand-held transmitter. • Press the LEARN button on the Garage ...See also:
Opening the hood
1. Inside the vehicle, pull the hood
release handle located under the
bottom of the instrument panel.
2. At the front of the vehicle, lift up
on the auxiliary latch handle located
in the center b ...
Towing the vehicle with the rear axle raised
Only possible on vehicles without 4MATIC.
When towing your vehicle with the rear axle raised, it is important that you
observe the safety instructions ().
The ignition must be switched off if y ...
Foreword
Thank you for choosing Hyundai. We are pleased to welcome you to the growing
number of discriminating people who
drive Hyundais. The advanced engineering and high-quality construction of each
Hy ...