Jeep Liberty: To Arm The System
1. Remove the key from the ignition switch and exit the vehicle.
2. Lock the doors and liftgate by pressing the power door LOCK switch or the LOCK button on the Remote Keyless Entry (RKE) transmitter.
NOTE: The Vehicle Security Alarm will not arm if you lock the doors with the manual door lock plungers or the driver’s door lock cylinder.
3. Close all doors. The Vehicle Security Light in the instrument cluster will flash rapidly for about 16 seconds to signal that the Vehicle Security Alarm is arming.
During this period, opening any door or the liftgate will cancel the arming process. If the Vehicle Security Alarm is set successfully, the Vehicle Security Light will flash at a slower rate to indicate the alarm is armed.
NOTE: For added security, whenever the Security Alarm is armed, the HomeLink /Garage Door Opener (if equipped) is disabled as well.
Rearming Of The System
If something triggers the Vehicle Security Alarm, and no action is taken to disarm it, the Vehicle Security Alarm will turn off the horn after three minutes, turn off all of the visual signals a ...To Disarm The System
Either press the UNLOCK button on the RKE transmitter or insert a valid Sentry Key into the ignition lock cylinder and turn the key to the ON/RUN position. NOTE: • Unlocking the doors with th ...See also:
Brake/Clutch fluid
Brake and clutch (if equipped) systems are supplied from the same
reservoir.
The fluid level will drop slowly as the
brakes wear, and will rise when the
brake components are replaced. Fluid
lev ...
Interior Convenience Items
Interior Convenience Items ...
Additional Safety Precautions
Never hold an infant or child on
your lap. If you are not wearing a
seat belt in a crash, you could be
thrown forward and crush the
child against the dashboard or a
seat-back. If you are wea ...