Volvo XC60: Low beams
When the engine is started, the low beams are activated automatically (daytime running lights) if the headlight control is in position 0 or .
Daytime running lights can be deactivated in the MY CAR menu system under Settings Car settings Light settings Daytime running lights.
However, please be aware that these lights may not be deactivated in Canada.
NOTE
• The use of daytime running lights is
mandatory in Canada.
• Continuous high beams cannot be activated
when the headlight switch is in
position . High beam flash
will
function in this position.
High/low beam headlights
Continuous high beams 1. Set the ignition to mode II. 2. With the light switch in position 0 or , pull the turn signal lever toward the steering wheel to position 2 to toggle between high an ...Active Bending Lights (ABL)
Headlight pattern with the Active Bending Light function deactivated (left) and activated (right) When this function is activated, the headlight beams adjust laterally to help light up a curve ...See also:
Starting the Engine
Before Starting the Engine
1) Make sure the parking brake is set fully. 2) Manual Transmission – Shift into
“N” (Neutral) and depress the clutch pedal all the way to the floor. Hold it while ...
Off-road recovery
If the right side or left side wheels leave the road
surface, maintain control of the vehicle by
following the procedure below. Please note that
this procedure is only a general guide. The
veh ...
Adjusting the Sound
Press the SOUND (TUNE) knob
repeatedly to display the BASS,
TREBLE, FADER, BALANCE, and
SVC (speed-sensitive volume
compensation) settings.
BASS - Adjusts the bass.
TREBLE - Adjusts the treb ...