Jeep Liberty: Loose Fuel Filler Cap Message
If the vehicle diagnostic system determines that the fuel filler cap is loose, improperly installed, or damaged, a “gASCAP” message will display in the odometer or a “CHECK gASCAP” message will be displayed in the Electronic Vehicle Information Center (EVIC). Refer to “Electronic Vehicle Information Center (EVIC)” in “Understanding Your Instrument Panel” for further information.
Tighten the gas cap until a clicking sound is heard.
This is an indication that the gas cap is properly tightened.
Press the odometer reset button to turn the message off.
If the problem persists, the message will appear the next time the vehicle is started. This might indicate a damaged cap. If the problem is detected twice in a row, the system will turn on the MIL. Resolving the problem will turn the MIL light off.
Onboard Diagnostic System — OBD II
Your vehicle is equipped with a sophisticated onboard
diagnostic system called OBD II. This system monitors
the performance of the emissions, engine, and automatic
transmission control systems. ...
Emissions Inspection And Maintenance Programs
In some localities, it may be a legal requirement to pass
an inspection of your vehicle’s emissions control system.
Failure to pass could prevent vehicle registration.
For states that require ...
See also:
Operation
Depending on the date of manufacture of your vehicle, the
or
symbol for the automatic headlamp mode/daytime
running lamps is located on the light switch.
Illustration: light switch with the
...
Diesel glow plug (amber)
Diesel glow plug (amber)
Illuminates when the ignition is
switched on to indicate that the
glow plugs are active. Wait until
the lamp extinguishes before starting the
engine. ...
Positions for towing hitch receiver and hitch ball
1 Weight carrying ball position:
41.4 in. (1051.1 mm)
2 Hitch receiver pin hole position:
32.4 in. (821.8 mm) ...
