Jeep Liberty: ESN/SID Access
With the ignition switch in the ON/RUN or ACC position and the radio on, press the SETUP button and scroll using the TUNE/SCROLL control knob until Sirius ID is selected. Press the TUNE/SCROLL control knob and the Sirius ID number will display. The Sirius ID number display will time out in two minutes. Press any button on the radio to exit this screen.
Electronic Serial Number/Sirius Identification Number (ESN/SID)
Please have the following information available when calling: 1. The Electronic Serial Number/Sirius Identification Number (ESN/SID). 2. Your Vehicle Identification Number. To access the ESN/SI ...Selecting Uconnect™ Multimedia (Satellite) Mode
Press the SAT button until SAT appears in the display.A CD may remain in the radio while in the Satellite radio mode. ...See also:
Seat belt inspection
● Check the belts for cuts, worn or frayed webbing and for cracked or deformed metallic
parts. Replace the belt assembly if defective.
● A dirty belt should be cleaned with neutral d ...
Changing the remote control batteries
- Do not let dust, oil or water get on
or in the remote engine start
transmitter when replacing the
battery.
- Be careful not to damage the
printed circuit board in the remote
engine st ...
Folder selection (only when connecting USB storage device)
Refer to “Folder selection”.
NOTE
When an iPod® is connected, you
cannot select a folder. ...