Jeep Liberty: Adding Fluid
Fluid should be added only to fill hole until fluid begins to run out of the hole.
Fluid Level Check
The fluid level should be to the bottom edge of the fill hole (1) when the vehicle is in a level position. 1 — Fill Plug 2 — Drain Plug ...Draining Fluid
First remove the fill plug (1), then the drain plug (2). Recommended tightening torque for the drain and fill plugs is 15–25 ft lbs (20–34 N·m). CAUTION! Do not over-tighten the plugs. You ...See also:
Shifting Procedures
NOTE: If any of the requirements to select a new
transfer case position have not been met, the transfer case
will not shift, the indicator light for the previous position
will remain on, and the ...
Backing up on a steep uphill
Backing up on a steep uphill
When backing up the vehicle up a hill, the
distance guide lines and the vehicle width guide
lines are shown closer than the actual distance.
For example, the displ ...
Temperature
The temperature grades are A (the
highest), B, and C, representing the
tire’s resistance to the generation of
heat and its ability to dissipate heat
when tested under controlled
conditions ...