Jeep Liberty: Rear Tail/Stop, Turn Signal, And Back-Up Lamp
1. Open the liftgate.
2. Remove the screws that fasten the taillamp housing to the vehicle.
3. Pull the taillamp housing straight back to separate it from the vehicle.
4. Disconnect the electrical connector.
5. Remove the two screws that fasten the back plate to the taillamp housing.
6. Separate the back plate from the taillamp housing.
7. Pull the appropriate bulb(s) out of the back plate and insert the replacement bulb(s).
8. Install the back plate and screws into the taillamp housing.
9. Connect the electrical connector.
10. Install the taillamp housing and screws.
11. Close the liftgate.
Front Fog Lamp
1. Open the hood. 2. Reach behind the headlamp housing to access the bulb. 3. Rotate the bulb’s socket counterclockwise, and remove the bulb and socket assembly from the fog lamp housing. 4. ...Fluid Capacities
...See also:
Points of interest (POI)
After selecting Points of interest from the
menu, touch Name to input the POI name, for
example, Petrol to display fuel stations on the
map, or touch List for a list of POIs.
Alternatively, choose ...
Cleaning the interior
To Clean the Vinyl Upholstery
To clean the vinyl upholstery, first remove loose
dirt and dust with a vacuum cleaner. Then apply
a solution of mild soap or detergent and water
using a clean spon ...
Introduction
The laminated panoramic roof is divided into
two sections.
• The rear glass section is fixed in place and
cannot be moved.
• The front glass section can be slid horizontally
to the open or ...