Jeep Liberty: Tire Chains - Starting And Operating - Jeep Liberty Owner's ManualJeep Liberty: Tire Chains

Use only compact chains, or other traction aids that meet SAE type “Class S” specifications. Chains must be the proper size for the vehicle, as recommended by the chain manufacturer. In addition, only install tire chains of the rear tires with P225/75R16 or smaller tires.

CAUTION!
To avoid damage to your vehicle, tires, or chains, observe the following precautions:

• Do not use tire chains on vehicles equipped with tires other than P225/75R16 or smaller tires. There may not be adequate clearance for the chains and you are risking structural or body damage to your vehicle.

• Because of limited chain clearance between tires and other suspension components, it is important that only chains in good condition are used. Broken chains can cause serious vehicle damage. Stop the vehicle immediately if noise occurs that could suggest chain breakage. Remove the damaged parts of the chain before further use.

• Install chains on the rear wheels as tightly as possible and then retighten after driving about 1⁄2 mile (0.8 km).

• Do not exceed 45 mph (72 km/h).

• Drive cautiously and avoid severe turns and large bumps, especially with a loaded vehicle.

• Use on Rear Wheels only.

• Do not drive for a prolonged period on dry pavement.

• Observe the tire chain manufacturer’s instructions on method of installation, operating speed, and conditions for use. Always use the lower suggested operating speed of the chain manufacturer if different from the speed recommended by the manufacturer.

These cautions apply to all chain traction devices, including link and cable (radial) chains.

    Replacement Tires
    The tires on your new vehicle provide a balance of many characteristics. They should be inspected regularly for wear and correct cold tire inflation pressure. The manufacturer strongly recommend ...

    Tire Rotation Recommendations
    The tires on the front and rear of your vehicle operate at different loads and perform different steering, handling, and braking functions. For these reasons, they wear at unequal rates. These ...

    See also:

    New vehicle break-in driving – the first 1,000 miles (1,600 km)
    The performance and long life of your vehicle are dependent on how you handle and care for your vehicle while it is new. Follow these instructions during the first 1,000 miles (1,600 km): - D ...

    Dome Lamps
    There are front and rear dome lamps. The dome lamp controls are located in the overhead console. To change the settings, press the following: (Dome Lamp Override): Turns the lamps off, even whe ...

    AM
    The range for most AM stations is greater than for FM, especially at night. The longer range can cause station frequencies to interfere with each other. Static can occur when things like storms an ...