Jeep Liberty: Automatic Operation - Automatic Temperature Control (ATC) — If Equipped - Climate Controls - Understanding Your Instrument Panel - Jeep Liberty Owner's ManualJeep Liberty: Automatic Operation

The Automatic Temperature Control system automatically maintains the climate in the cabin of the vehicle at the comfort levels desired by the driver and passenger.

Operation of the system is quite simple.

1. Turn the Mode Control knob (on the right) and the Blower Control knob (on the left) to AUTO.

NOTE: The AUTO position performs best for front seat occupants only.

2. Dial in the temperature you would

2. Dial in the temperature you would like the system to maintain by rotating the Temperature Control knob. Once the comfort level is selected, the system will maintain that level automatically using the heating system. Should the desired comfort level require air conditioning, the system will automatically make the adjustment.

You will experience the greatest efficiency by simply allowing the system to function automatically. Selecting the “O” (OFF) position on the blower control stops the system completely and closes the outside air intake.

The recommended setting for maximum comfort is 72°F (22°C) for the average person; however, this may vary.

NOTE:
• The temperature setting can be adjusted at anytime without affecting automatic operation.

• Pressing the Air Conditioning Control button while in AUTO mode will cause the LED in the control button to flash three times and then turn off. This indicates that the system is in AUTO mode and requesting the air conditioning is not necessary.

• If your air conditioning performance seems lower than expected, check the front of the A/C condenser located in front of the radiator for an accumulation of dirt or insects. Clean with a gentle water spray from behind the radiator and through the condenser. Fabric front fascia protectors may reduce airflow to the condenser, reducing air conditioning performance.

    Automatic Temperature Control (ATC) — If Equipped
    Automatic Temperature Control ...

    Blower Control
    For full automatic operation or for automatic blower operation, turn the knob to the AUTO position. In manual mode there are six blower speeds that can be individual selected. In off positio ...

    See also:

    SCAN (only when connecting USB storage device)
    Scan is operated in the same way a CD is played. For details, refer to “Scan (type A, B and C audio)”. NOTE When an iPod® is connected, you cannot select the SCAN mode. ...

    Recirculation with pollution and humidity sensing
    - Press the AUTO button briefly to activate timed recirculation. The AUTO LED will illuminate. The system automatically selects fresh and recirculated air dependent on pollution and cabin humidit ...

    Basic sound settings
    Press SOUND to display the basic sound setting menu (Bass, Treble, etc). Continue pressing SOUND or OK/MENU to display the other setting alternatives. Adjust the setting by turning TUNE and sav ...