Jeep Liberty: Hazard Warning Flashers
The Hazard Warning flasher switch is located in the switch bank below the climate controls.
Press the switch to turn on the Hazard Warning flasher. When the switch is activated, all directional turn signals will flash on and off to warn oncoming traffic of an emergency. Press the switch a second time to turn off the Hazard Warning flashers.
This is an emergency warning system and it should not be used when the vehicle is in motion. Use it when your vehicle is disabled and it is creating a safety hazard for other motorists.
When you must leave the vehicle to seek assistance, the Hazard Warning flashers will continue to operate even though the ignition is placed in the OFF position.
NOTE: With extended use the Hazard Warning flashers may wear down your battery.
If Your Engine Overheats
In any of the following situations, you can reduce the potential for overheating your engine by taking the appropriate action. • On the highways — slow down. • In city traffic — while st ...See also:
Service portfolio
Vehicle identification information is recorded in
the Service Portfolio by the selling dealer. The
book also includes important information
about customer care, owner issues, routine
servicing, pa ...
Vehicle load limit – how to determine
The load capacity of your vehicle is
determined by weight, not by available
cargo space. The load limit of
your vehicle is shown on the
vehicle placard attached to the
driver’s side B-pill ...
Satellite Radio
Vehicles with an XMâ„¢ satellite radio tuner and a valid XM satellite radio subscription
can receive XM programming. ...