GMC Terrain: New Vehicle Break-In - Starting and Operating - Driving and Operating - GMC Terrain Owner's ManualGMC Terrain: New Vehicle Break-In

Notice: The vehicle does not need an elaborate break-in. But it will perform better in the long run if you follow these guidelines:

○ Do not drive at any one constant speed, fast or slow, for the first 805 km (500 mi). Do not make full-throttle starts. Avoid downshifting to brake or slow the vehicle.

○ During the first 1 000 km (600 mi), avoid using more than moderate acceleration in lower gears and avoid vehicle speeds above 110 km/h (68 mph).

○ Between the first 1 000 km (600 mi) and 5 000 km (3,000 mi), heavy acceleration in lower gears can be used. Vehicle speeds above 110 km/h (68 mph) should be limited to five minutes per use.

○ Avoid making hard stops for the first 322 km (200 mi) or so. During this time the new brake linings are not yet broken in. Hard stops with new linings can mean premature wear and earlier replacement. Follow this breaking-in guideline every time you get new brake linings.

○ Do not tow a trailer during break-in. See Driving Characteristics and Towing Tips on page 9‑57 for the trailer towing capabilities of your vehicle and more information.

Following break-in, engine speed and load can be gradually increased.

    Ignition Positions
    The ignition switch has four different positions. Notice: Using a tool to force the key to turn in the ignition could cause damage to the switch or break the key. Use the correct key, make sure i ...

    See also:

    Rolling re-start
    If the engine is switched off while the vehicle is moving, a rolling re-start can be initiated. Automatic transmission - select neutral (N) and then press the engine START/STOP button. When the en ...

    Installing the spare tire
    The spare tire is designed for emergency use. (See specific instructions under the heading “Wheels and tires” in the “8. Maintenance and do-it-yourself” section.) 1. Clean any mud or d ...

    Tire size
    ■ Typical tire size information The illustration indicates typical tire size. 1 Tire use (P = Passenger car, T = Temporary use) 2 Section width (millimeters) 3 Aspect ratio (tire heigh ...