Mercedes-Benz GLK-Class: Important notes on the use of KEYLESSGO - KEYLESS-GO - SmartKey - Opening/closing - Mercedes-Benz GLK-Class Owner's ManualMercedes-Benz GLK-Class: Important notes on the use of KEYLESSGO

  • The KEYLESS-GO key can be used like a conventional key.
  • You can combine KEYLESS-GO functions with those of a conventional key, e.g. unlock with KEYLESS-GO and lock with the Always carry your KEYLESS-GO key on your person. button.
  • Always carry your KEYLESS-GO key on your person.
  • Do not keep the KEYLESS-GO key together with:
    • - electronic devices, e.g. a mobile phone or another key
    • - metallic objects, e.g. coins or metal foil.

    This can affect the functionality of KEYLESS-GO.

  • When locking and unlocking using KEYLESS-GO, the distance between the SmartKey and the corresponding door handle must not exceed 3 ft (1 m).
  • If the vehicle is parked for more than 72 hours, the KEYLESS-GO function is deactivated. Pull the outer door handle and switch on the ignition to reactivate the KEYLESS-GO function.
  • If the KEYLESS-GO key is removed from the vehicle, it is possible that the system may not recognize the SmartKey. The vehicle can then not be locked or started using KEYLESS-GO.
  • If the KEYLESS-GO key has been removed from the vehicle, e.g. if a passenger leaves the vehicle with a KEYLESS-GO key:
    • - if the start/stop button is pressed or if an attempt is made to lock the vehicle with the locking button on the outer door handle, the Key Not Detected message appears in the multifunction display
    • - when the engine is running, the red Key Not Detected message appears in the multifunction display as you pull away. Find the KEYLESS-GO key and change its position in the vehicle. Carry the KEYLESS-GO key in your shirt pocket, for example.
  • If you have started the engine with the Start/Stop button, you can switch it off again by: - pressing the Start/Stop button again
    - inserting the KEYLESS-GO key into the ignition lock if the vehicle is stationary and the automatic transmission is in park position P.
  • You could unlock the vehicle by mistake if the distance between the KEYLESS-GO key and the vehicle is less than 3 ft (1 m) and:
    - an exterior door handle is hit by a water
    jet
    or
    - you clean an exterior door handle.
  • Bear in mind that the engine can be started by any of the vehicle occupants if there is a KEYLESS-GO key in the vehicle.

  • To unlock the vehicle: touch the inner surface of the door handle.
  • To lock the vehicle: touch sensor surface 1.
  • Convenience closing feature: touch recessed sensor surface 2 for an extended period ().

If you pull on the handle of the tailgate, only the cargo compartment of the vehicle is unlocked.

    General notes
    USA only: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. this device must a ...

    Changing the settings of the locking system
    You can change the setting of the locking system in such a way that only the driver's door and the fuel filler flap are unlocked. This is useful if you frequently travel on your own. To ch ...

    See also:

    Air Bag Warning Light
    The light should come on and remain on for four to eight seconds as a bulb check when the ignition switch is first turned ON. If the light is not lit during starting, see your authorized dealer. ...

    Windshield Wipers And Washers
    The windshield wiper/washer control lever is located on the right side of the steering column. The front wipers are operated by rotating a switch, located at the end of the lever. For informatio ...

    Operation
    Controls and display 1 Resume previous settings, increase speed (each additional press increases speed by 1 mph (approximately 2 km/h). 2 Standby mode on/off 3 Set time interval 4 Put in activ ...