Nissan Rogue: If your vehicle is stolen
If your vehicle is stolen, you should change the codes of any non-rolling code device that has been programmed into HomeLink®. Consult the Owner’s Manual of each device or call the manufacturer or dealer of those devices for additional information.
When your vehicle is recovered, you will need to reprogram the HomeLink® Universal Transceiver with your new transmitter information.
FCC Notice:
This device complies with FCC rules part 15. Operation is subject to the following two conditions: (1) This device may not cause harmful interference and (2) This device must accept any interference that may be received, including interference that may cause undesired operation.
The transmitter has been tested and complies with FCC and DOC/MDC rules.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the device.
DOC: ISTC 1763K1313
FCC I.D.: CB2V67690
Reprogramming a single HomeLink® button
To reprogram a HomeLink® Universal Transceiver
button, complete the following.
1. Push and hold the desired HomeLink®
button. Do not release the button until step
4 has been completed.
2. Wh ...
See also:
Installing the cover
1. Press the end piece on one side of the
cargo area cover into the retaining bracket
in the side panel of the cargo area 1.
2. Do the same on the opposite side 2.
3. Press both sides of the cov ...
Adding Washer Fluid
The windshield and rear window washers share the same
fluid reservoir. The fluid reservoir is located in the front
of the engine compartment. Be sure to check the fluid
level in the reservoir at ...
Trailer or vehicle towing
If you are considering towing with your car, you
should first check with your State's Department
of Motor Vehicles to determine their legal requirements.
Since laws vary from State to State the ...
