GMC Terrain: Adding Washer Fluid - Washer Fluid - Vehicle Checks - Vehicle Care - GMC Terrain Owner's ManualGMC Terrain: Adding Washer Fluid

Open the cap with the washer symbol on it and add washer fluid until full. See

Open the cap with the washer symbol on it and add washer fluid until full. See Engine Compartment Overview on page 10‑6 for reservoir location.

Notice

○ When using concentrated washer fluid, follow the manufacturer's instructions for adding water.
○ Do not mix water with ready-to-use washer fluid. Water can cause the solution to freeze and damage the washer fluid tank and other parts of the washer system. Also, water does not clean as well as washer fluid.
○ Fill the washer fluid tank only three-quarters full when it is very cold. This allows for fluid expansion if freezing occurs, which could damage the tank if it is completely full.
○ Do not use engine coolant (antifreeze) in the windshield washer. It can damage the windshield washer system and paint.

    What to Use
    Read the manufacturer's instructions before refilling the windshield washer fluid. If operating the vehicle in an area where the temperature may fall below freezing, use a fluid that has suffi ...

    Brakes
    This vehicle has disc brakes. Disc brake pads have built-in wear indicators that make a high-pitched warning sound when the brake pads are worn and new pads are needed. The sound can come and go o ...

    See also:

    Front Seat Heater (if equipped)
    Front Seat Heater (if equipped) With the ignition switch in the “ON” position, push in one or both of the seat heater switches to warm the corresponding seat(s). The indicator light below th ...

    Rear Seat Audio (RSA) System
    Vehicles with this feature allow the rear seat passengers to listen to and control any of the music sources: radio, CDs, DVDs, or other auxiliary sources. RSA can only control music sources that t ...

    Changing the passkey
    1 Select “Passkey” using . 2 Select a 4 to 8-digit passkey using . Input the number 1 digit at a time. 3 When the entire number to be registered as a passkey has been input, press again. I ...