GMC Terrain: Floor Mats - Appearance Care - Vehicle Care - GMC Terrain Owner's ManualGMC Terrain: Floor Mats

WARNING

If a floor mat is the wrong size or is not properly installed, it can interfere with the pedals. Interference with the pedals can cause unintended acceleration and/or increased stopping distance which can cause a crash and injury. Make sure the floor mat does not interfere with the pedals.

Use the following guidelines for proper floor mat usage.

○ The original equipment floor mats were designed for your vehicle. If the floor mats need replacing, it is recommended that GM certified floor mats be purchased. Non-GM floor mats may not fit properly and may interfere with the accelerator or brake pedal. Always check that the floor mats do not interfere with the pedals.
○ Use the floor mat with the correct side up. Do not turn it over.
○ Do not place anything on top of the driver side floor mat.
○ Use only a single floor mat on the driver side.
○ Do not place one floor mat on top of another.

Instrument Panel, Vinyl, and Other Plastic Surfaces
Use a soft microfiber cloth dampened with water to remove dust and loose dirt. For a more thorough cleaning, use a soft microfiber cloth dampened with a mild soap solution. Notice: Soaking or sat ...

Removing and Replacing the Floor Mat
The driver side floor mat is held in place by two retainers. 1. Pull up on the rear of the floor mat to unlock each retainer and remove. 2. Reinstall by lining up the floor mat retainer openings o ...

See also:

Engine compartment
(2.7 Gasoline) 1. Power steering fluid reservoir 2. Brake & Clutch fluid reservoir 3. Air cleaner 4. Fuse and Relay box 5. Windshield washer fluid reservoir 6. Engine oil level dips ...

Hood release
1. Pull the release knob to unlatch the hood. 2. Push the secondary latch lever to the left and lift the hood. 3. Hold the hood open with the support rod. Before closing the hood, return ...

License plate lighting
1. Remove the screws with a screwdriver. 2. Carefully detach the entire bulb housing and pull it out. 3. Replace the bulb. 4. Reinsert the entire bulb housing and tighten the screws. ...