Nissan Rogue: Connecting procedure - Getting started - Bluetooth® Hands-Free Phone System (if so equipped) - Center display, heater, air conditioner, audio, phone 
and voice recognition systems - Nissan Rogue Owner's ManualNissan Rogue: Connecting procedure

NOTE:
The connecting procedure must be performed when the vehicle is stationary. If the vehicle starts moving during the procedure, the procedure will be cancelled.

1. Push the  button on the

1. Push the steering wheel. button on the steering wheel.

The system announces the available commands.

2. Say: “Connect Phone” A . The system acknowledges the command and announces the next set of available commands.

3. Say: “Add phone” B . The system acknowledges the command and asks you to initiate pairing from the phone handset C .

The connecting procedure of the cellular phone varies according to each cellular phone. See the cellular phone Owner’s Manual for details. You can also visit www.

nissanusa.com/bluetooth for instructions on connecting NISSAN recommended cellular phones.

When prompted for a Passkey code, enter “1234” from the handset. The Passkey code “1234” has been assigned by NISSAN and cannot be changed.

4. The system asks you to say a name for the phone D .

If the name is too long or too short, the system tells you, then prompts you for a name again.

Also, if more than one phone is connected and the name sounds too much like a name already used, the system tells you, then prompts you for a name again.

    Choosing a language
    You can interact with the Bluetooth® Hands- Free Phone System using English, Spanish or French. To change the language, perform the following. 1. Push and hold the button for more than 5 s ...

    Making a call by entering a phone number
    1. Push the button on steering wheel. A tone will sound. 2. Say: “Call” A . The system acknowledges the command and announces the next set of available commands. 3. Say: “Phone Numb ...

    See also:

    Engine
    Display messages Possible causes/consequences and Solutions Check Coolant Level See Operator's Manual The coolant level is too low. Add coolant, observing the war ...

    Remote Transmitter
    LOCK - Press this button once to lock all doors and the tailgate. Some exterior lights will flash once. When you push LOCK twice within 5 seconds, you will hear a beep to verify that the ...

    Starting your vehicle
    Starting your vehicle The remote control start system is activated by pressing the “” button twice within 3 seconds on your remote control transmitter. The system will check certain p ...