Subaru Forester: Compass calibration
1. If a “C” is displayed in the compass window, the compass needs to be calibrated.
2. Drive the vehicle in a circle at 5 mph (8 km/h) or less until the display reads a direction.
3. You can also calibrate the compass by driving your vehicle on your everyday routine. The compass will be calibrated once it has tracked a complete circle.
4. To recalibrate your compass, push and hold the compass display button for 9 seconds until a “C” appears in the compass window.
5. Calibrate the compass according to step 2 or step 3.
Compass zone adjustment
Compass calibration zones
1. Refer to the “Compass calibration
zones” map shown above to verify that
the compass zone setting is correct for
your geographical location.
2. Press and ...
HomeLink® Wireless Control System
The HomeLink® Wireless Control System
can be used to activate remote control
devices such as gate operators, garage
door openers, door locks, home lighting
and security systems.
There are ...
See also:
If the Engine is Flooded
If the engine is flooded with gasoline, it may be hard to start. If this happens,
press the accelerator pedal all the way to the floor and hold it there while cranking
the engine. (Do not operate ...
Cup Holder and Storage Bin (if equipped)
Cup holders and a storage bin are provided as shown.
To access a bin, push the release button.
To use the console bin, pull the lever up and open the lid.
To use the rear cup holders, open th ...
Electronic compass (if equipped)
The compass heading is displayed in the center stack display.
The compass reading may be affected when you drive near large
buildings, bridges, power lines and powerful broadcast antenna. Magnetic ...
