Nissan Rogue: Clearing the programmed information
Individual buttons cannot be cleared, however to clear all programming, push and hold the two outside buttons and release when the indicator light begins to flash (in approximately 20 seconds).
Programming trouble-diagnosis
If HomeLink® does not quickly learn the handheld transmitter information: - replace the hand-held transmitter batteries with new batteries. - position the hand-held transmitter with its batt ...Reprogramming a single HomeLink® button
To reprogram a HomeLink® Universal Transceiver button, complete the following. 1. Push and hold the desired HomeLink® button. Do not release the button until step 4 has been completed. 2. Wh ...See also:
Introduction
System overview
1 Cell phone
2 Location of the microphone
3 Steering wheel keypad
4 Center console control panel and display ...
Storing the ball coupling
WARNING
Do not carry the ball coupling in the vehicle interior if it is not secured.
Otherwise, you and others could be injured by the ball coupling being thrown
around if you:
brake shar ...
Seat heaters
1 Heats the driver’s seat
2 Heats the front passenger’s
seat
The indicator light is on while
the seat heater is operating.
Push the switch once again to
turn off the seat heater.
■T ...