Range Rover Evoque: Cleaning the exterior
Remove any heavy deposits of
mud and
dirt with a hose before washing the
vehicle.
Never aim a hose water jet directly at
the engine air intake, heater air intakes,
body seals or at any components which
may be damaged.
Do not use a high pressure washer or
steam cleaner in the engine
compartment.
Following cleaning of the vehicle
exterior (particularly with a pressure
washer), it is recommended that the
vehicle is taken for a short drive to dry
out the brakes.
Substances which are corrosive, such
as bird droppings and tree resin, can
damage the vehicle’s paintwork and
should be removed as soon as possible.
Use only cleaning products approved
for use on vehicles.
Camera lenses must be treated with
care. Clean with a low pressure hose
and wipe with a damp cloth.
Note: Do not apply polish to any unpainted areas of the bumper mouldings. It will become ingrained in the textured finish.
READ NEXT:
Using white spirit
Stubborn stains such as tar spots and grease
may require the use of white spirt. After use,
ensure the area is washed immediately with
warm soapy water to remove all traces of the
spirit.
Underbody maintenance
Regularly flush the underbody with plain water,
and pay particular attention to areas where
mud and debris collect.
If damage or corrosion are detected, have the
vehicle checked by your Dealer/Aut
Cleaning after off-road driving
Ensure that the areas around
air intakes
and the front grille are clean and clear of
debris. Pay particular attention to the
lower grille and radiator. Failure to do
so may cause the engine t
SEE MORE:
Rear Bumper Mounting
Removal
NOTE: The rear bumper mounting is manufactured from mild steel.
1. In this procedure, to make sure the vehicle is correctly
aligned, it must be placed on an approved alignment
jig.
2. The rear bumper mounting is replaced in conjunction with:
Rear bumper cover
Rear bumper
Back panel
3.
Wiper blade replacement
Fit only replacement wiper blades that are
identical to the original specification.
Before changing a wiper blade, the wiper arms
must be set in the ‘service’ position as follows;
Note: The Smart Key must remain in the
vehicle while wiper blades are replaced.
1. Ensure that the ignition is
