Range Rover Evoque: Changing a bulb
If the lighting has just
been switched
off, give the bulbs time to cool.
Handling them when hot may cause
personal injury.
Always replace bulbs with
the correct
type and specification. If you are in any
doubt contact your Land Rover
Dealer/Authorised Repairer for advice.
See 199, BULB SPECIFICATION
CHART.
Before attempting a bulb change,
ensure that the ignition and affected
lamp are turned off. If the circuit
remains live, a short circuit can occur
which may damage the vehicle
electrical system.
Not all bulbs are replaceable. The following
bulbs can be replaced:
- Headlamps.
- Direction indicators.
- Side lamps.
- Reversing lamp.
- Rear fog lamp.
- Some interior lamps.
All other exterior lamps and some interior
lamps are LED (light emitting diode) lamps and
can be replaced only by a Land Rover
Dealer/Authorised Repairer.
All replacement procedures require the
removal of components to gain access to the
bulbs.
Moving a headlamp unit
should be
undertaken only by a qualified
technician. If in doubt, consult your
Land Rover Dealer.
Note: To change any bulb in a headlamp unit, a
cross head screwdriver and a 10mm spanner is
required.
READ NEXT:
High voltage is required to
ignite the
gas and metal vapour which are used
to power Xenon lamps. Contact with
this voltage can cause serious injury.
Replacement or maintenance of
Xenon lamps s
Moving the nearside headlamp unit to access
bulbs;
1. Remove the two plastic fixings.
2. Pull the tube up to release from the air box.
This will allow more room for
manoeuvrability.
3. Remove
Removing the nearside bulbs;
To gain more room for accessibility, follow
steps 1 and 2 for moving the nearside
headlamp unit.
1. At the back of the headlamp unit, remove
the indicator bulb hous
SEE MORE:
Introduction
CAUTION: Do not use any other heat shrink sleeve other than the approved
glue lined heat shrink sleeve mentioned
in the repair procedure.
The purpose of this document is to promote quick and efficient minor repair
to harness connectors or cables using
approved methods and the wiring
Operation of the transmission is controlled by the TCM which electrically
activates various solenoids to control the
transmission gear selection. The sequence of solenoid activation is based on
programmed information in the TCM memory
and physical transmission operating conditions such as vehicle
© 2011-2024 Copyright www.rrevoque.org