Honda CR-V: Winter Driving - Tires - Maintenance - Honda CR-V Owner's ManualHonda CR-V: Winter Driving

Tires marked ‘‘M + S’’ or ‘‘All Season’’ on the sidewall have an allweather tread design suitable for most winter driving conditions.

For the best performance in snowy or icy conditions, you should install snow tires or tire chains. They may be required by local laws under certain conditions.

Snow Tires

If you mount snow tires on your vehicle, make sure they are radial tires of the same size and load range as original tires. Mount snow tires on all four wheels. The traction provided by snow tires on dry roads may be lower than your original tires.

Check with the tire dealer for maximum speed recommendations.

Tire Chains

Mount tire chains on your tires when required by driving conditions or local laws. Install them only on the front tires.

Because your vehicle has limited tire clearance, Honda strongly recommends using the chains listed below, made by Security Chain Company (SCC).

Cable-type: SCC Radial Chain TC2111MM

Using the wrong chains, or not

Using the wrong chains, or not properly installing chains, can damage the brake lines and cause a crash in which you can be seriously injured or killed.

Follow all instructions in this owner’s manual regarding the selection and use of tire chains.

When installing cables, follow the manufacturer’s instructions, and mount them as tight as you can.

Make sure they are not contacting the brake lines or suspension. Drive slowly with them installed. If you hear them coming into contact with the body or chassis, stop and investigate. Remove them as soon as you begin driving on cleared roads.

Traction devices that are the wrong

Traction devices that are the wrong size or improperly installed can damage your vehicle’s brake lines, suspension, body, and wheels. Stop driving if they are hitting any part of the vehicle.

    Wheel and Tire Specifications
    Wheels: 17 x 6 1/2J Tires: 225/65R17 102T ...

    Wheels
    Clean the wheels as you would the rest of the exterior. Wash them with the same solution, and rinse them thoroughly. If equipped Aluminum alloy wheels have a protective clear-coat that keeps ...

    See also:

    Extra high beam
    1. Remove the headlight housing from the vehicle (see page 322). 2. Remove the cover over the bulbs (see page 323). 3. Disconnect the wiring connector from the bulb holder. 4. Remove the bu ...

    Adding Washer Fluid
    The windshield and rear window washers share the same fluid reservoir. The fluid reservoir is located in the front of the engine compartment. Be sure to check the fluid level in the reservoir at ...

    Locking and unlocking from the outside
    NOTE If you unlock the driver’s door with a key and open the door while the alarm system is armed, the alarm system is triggered and the vehicle’s horn sounds. In this case, perform any ...