Subaru Forester: Windshield wiper blade assembly
1. Raise the wiper arm off the windshield.
1) Open the cover
2) Pull down the wiper blade
2. Remove the wiper blade assembly by opening the cover and pulling it down in the direction shown in the illustration.
3. Install the wiper blade assembly to the wiper arm. Make sure that it locks in place.
4. Hold the wiper arm by hand and slowly lower it in position.
Replacement of wiper blades
Grease, wax, insects, or other material on the windshield or the wiper blade results in jerky wiper operation and streaking on the glass. If you cannot remove the streaks after operating the w ...Windshield wiper blade rubber
1) Support 1. Grasp the locked end of the blade rubber assembly and pull it firmly until the stoppers on the rubber are free of the support. 1) Metal spines 2. If the new blade rubber is ...See also:
Jump starting
WARNING: The gases around the battery can explode if
exposed to flames, sparks, or lit cigarettes. An explosion could
result in injury or vehicle damage.
WARNING: Batteries contain sulfuric acid ...
Cleaning Exterior Lamps/ Lenses and Emblems
Use only lukewarm or cold water, a soft cloth, and a car washing soap to clean
exterior lamps and lenses. Follow instructions under "Washing the Vehicle" later
in this section. ...
XM Messages
XL (Explicit Language Channels): These channels, or any others, can be blocked
by request, by calling 1-800-929-2100 in the U.S. and 1-877-438-9677 in Canada.
XM Updating: The encryption code in th ...