Range Rover Evoque: Windscreen wipers

Windscreen wipers
Windscreen wipers

1. Rotate the collar to adjust the intermittent period. The intermittent delay period will vary and is controlled by either vehicle speed or a rain sensor. The control must be in position (4) to be operational. This is a dealer configurable option.

2. High speed wipe.

3. Low speed wipe.

4. AUTO or intermittent wipe. Controlled by either a rain sensor or vehicle speed. In this position, the rain sensor becomes active and will determine when the wipers are required to operate. If the rain sensor is not configured by your dealer, intermittent wipe will operate in conjunction with the setting of control (1).

5. Rear window wash/wipe: - Press and hold to operate the rear washer and wiper. The wiper will operate for two further wipes after the button is released. After a few seconds a drip wipe process will clear any residual water.

6. Single wipe of windscreen, or hold down for further continuous wipes.

7. Windscreen wash/wipe: - Pull and hold to operate the front washers and wipers. The wipers will operate for three further wipes after the stalk is released. After a few seconds a drip wipe will clear any residual water.

8. INT - rear wiper, intermittent operation.

The intermittent delay period is controlled by adjusting the collar (1). The delay period and number of wipes will then be adjusted automatically depending on vehicle speed.This is a dealer configurable option.

9. ON - rear wiper, continuous operation.

wipers Do not operate the windscreen wipers on a dry screen.
In freezing or very hot conditions, ensure that the wipers have not stuck to the glass.
Remove any snow, ice or frost from the screen, around the wiper arms and blades and the screen scuttle, before operating the wipers.

Note: If wiper blades become stuck or jammed, an electronic cut-out will temporarily halt wiper operation. If this happens, switch off the wipers and the ignition. Clear any obstructions and free the wiper blades, before attempting to switch on the ignition.

Note: Front wipers will not operate while the bonnet is open and vehicle speed is below 3km/h (1.9mph).

READ NEXT:

 Rain sensor/speed sensitive wiper control

Intermittent operation of the wipers is controlled initially by either vehicle speed or a rain sensor located at the upper edge of the windscreen. Both methods of control will clear the screens ad

 Rain sensor

Ensure that the wipers are switched off before entering a car wash. If the rain sensitive wipers operate during the car washing process, damage may occur to the wiper mechanism. The rain senso

 Speed sensitive wipers

If vehicle speed drops below 6km/h (3.7mph) with the wipers operating in positions (2) or (3), the wipers will switch to the next lowest speed. When vehicle speed increases to over 6km/h (3.7mph),

SEE MORE:

 Keyless start backup

If the vehicle has been unlocked using the emergency key blade or the Smart Key is not detected by the vehicle, it will be necessary to use the keyless start backup to disarm the alarm and start the engine. The keyless start backup can only be used when the message Smart Key Not Found Refer t

 Touch Screen (TS)

Touch Screen Display (FCDIM) The table below lists all Diagnostic Trouble Codes (DTCs) that could be logged in the Multifunction Display Module, for additional Diagnosis and Testing information refer to the relevant Diagnosis and Testing Section. For additional information, refer to: Information

© 2011-2024 Copyright www.rrevoque.org