Nissan Rogue: Vehicle set-up
1. Park the vehicle on a level surface and apply the parking brake.
2. Start the engine and let it idle until it reaches operating temperature.
3. Turn the engine off and wait more than 10 minutes.
4. Raise and support the vehicle using a suitable floor jack and safety jack stands.
- Place the safety jack stands under the vehicle jack-up points.
- A suitable adapter should be attached to the jack stand saddle.
Make sure the correct lifting and support points are used to avoid vehicle damage.
Changing engine oil and filter
Change the engine oil and filter according to the maintenance log shown in the NISSAN Service and Maintenance Guide. ...Engine oil and filter
1. Oil filler cap 2. Oil drain plug 3. Oil filter 1. Place a large drain pan under the drain plug. 2. Remove the oil filler cap. 3. Remove the drain plug with a wrench and completely drain ...See also:
Armrests
Each front seat has an armrest on
the side of the seat-back. To use it,
pivot it down.
The rear seat armrest is in the
center of the rear seat. Pivot it down
to use it. ...
Canadian/Gate Operator Programming
For programming transmitters in Canada/United States
that require the transmitter signals to “time-out” after
several seconds of transmission.
Canadian radio frequency laws require transmitte ...
Hitch ball
Choose a hitch ball of the proper size and
weight rating for your trailer:
- The required hitch ball size is stamped on
most trailer couplers. Most hitch balls also
have the size printed on to ...