Range Rover Evoque: Using wheel chocks

Note: Wheel chocks are not supplied as part of the tool kit.

Wheel chocks are a useful addition to a vehicle tool kit. Note the following advice when using wheel chocks.

the wheel Before raising the vehicle, the wheel diagonally opposite the one to be removed must be chocked.
Always chock the wheels using suitable wheel chocks. Place the chocks on both sides of the wheel diagonally opposite the wheel to be changed.
If jacking the vehicle on a slight slope is unavoidable, place the chocks on the downhill side of both wheels on the axle not being raised.

READ NEXT:

 Wheel changing safety

Before raising the vehicle or changing a wheel, ensure that you read and comply with the following warnings. Always find a safe place to stop, off the highway and away from traffic. Ensure tha

 Locking wheel nuts

Locking wheel nuts can be removed only by using the special adapter provided in the tool kit. Note: When the vehicle is first supplied, the adapter may be stored in the glove compartment. It shou

 Releasing locking wheel nuts

1. Insert the wheel nut adapter into the locking wheel nut, ensuring that it is fully engaged. 2. Locate the wheel brace over the adapter and unscrew the wheel nut half a turn counter clockwise.

SEE MORE:

 Daytime running lamps

Daytime running lamps are LED lamps. With the lighting control in the OFF position or in AUTO position while lighting conditions do not require headlamps on, then daytime running lamps will switch on automatically under the following conditions: - The engine is running. - The gear selector is

 Epb automatic use

EPB will be applied automatically if the ignition is switched off and the vehicle speed is below 3km/h (2mph). To prevent automatic operation, when the vehicle is stationary, press and hold the EPB switch in the release position. Within 5 seconds, switch off the ignition and continue to hold

© 2011-2024 Copyright www.rrevoque.org